1 files changed, 0 insertions, 110 deletions
diff --git a/by_os/Linux/rtorrent/.rtorrent.rc b/by_os/Linux/rtorrent/.rtorrent.rc
deleted file mode 100644
index 3dfa1a2..0000000
--- a/by_os/Linux/rtorrent/.rtorrent.rc
+++ /dev/null
@@ -1,110 +0,0 @@
-# This is an example resource file for rTorrent. Copy to
-# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
-# uncomment the options you wish to enable.
-
-# Maximum and minimum number of peers to connect to per torrent.
-#min_peers = 40
-#max_peers = 100
-
-# Same as above but for seeding completed torrents (-1 = same as downloading)
-#min_peers_seed = 10
-#max_peers_seed = 50
-
-# Maximum number of simultanious uploads per torrent.
-#max_uploads = 15
-
-# Global upload and download rate in KiB. "0" for unlimited.
-#download_rate = 0
-upload_rate = 10
-
-# Default directory to save the downloaded torrents.
-directory = ~/z/
-
-# Default session directory. Make sure you don't run multiple instance
-# of rtorrent using the same session directory. Perhaps using a
-# relative path?
-session = ~/z/
-
-# Watch a directory for new torrents, and stop those that have been
-# deleted.
-#schedule = watch_directory,5,5,load_start=./watch/*.torrent
-#schedule = untied_directory,5,5,stop_untied=
-schedule = low_diskspace,5,60,close_low_diskspace=100M
-
-# Close torrents when diskspace is low.
-#schedule = low_diskspace,5,60,close_low_diskspace=100M
-
-# Stop torrents when reaching upload ratio in percent,
-# when also reaching total upload in bytes, or when
-# reaching final upload ratio in percent.
-# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
-#schedule = ratio,60,60,"stop_on_ratio=200,200M,2000"
-
-# The ip address reported to the tracker.
-#ip = 127.0.0.1
-#ip = rakshasa.no
-
-# The ip address the listening socket and outgoing connections is
-# bound to.
-#bind = 127.0.0.1
-#bind = rakshasa.no
-
-# Port range to use for listening.
-port_range = 49164-50164
-
-# Start opening ports at a random position within the port range.
-port_random = yes
-
-# Check hash for finished torrents. Might be usefull until the bug is
-# fixed that causes lack of diskspace not to be properly reported.
-#check_hash = no
-
-# Set whetever the client should try to connect to UDP trackers.
-#use_udp_trackers = yes
-
-# Alternative calls to bind and ip that should handle dynamic ip's.
-#schedule = ip_tick,0,1800,ip=rakshasa
-#schedule = bind_tick,0,1800,bind=rakshasa
-
-# Encryption options, set to none (default) or any combination of the following:
-# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
-#
-# The example value allows incoming encrypted connections, starts unencrypted
-# outgoing connections but retries with encryption if they fail, preferring
-# plaintext to RC4 encryption after the encrypted handshake
-#
-# encryption = allow_incoming,enable_retry,prefer_plaintext
-encryption = require
-
-# Enable DHT support for trackerless torrents or when all trackers are down.
-# May be set to "disable" (completely disable DHT), "off" (do not start DHT),
-# "auto" (start and stop DHT as needed), or "on" (start DHT immediately).
-# The default is "off". For DHT to work, a session directory must be defined.
-# 
-# dht = auto
-
-# UDP port to use for DHT. 
-# 
-# dht_port = 6881
-
-# Enable peer exchange (for torrents not marked private)
-#
-# peer_exchange = yes
-
-#
-# Do not modify the following parameters unless you know what you're doing.
-#
-
-# Hash read-ahead controls how many MB to request the kernel to read
-# ahead. If the value is too low the disk may not be fully utilized,
-# while if too high the kernel might not be able to keep the read
-# pages in memory thus end up trashing.
-#hash_read_ahead = 10
-
-# Interval between attempts to check the hash, in milliseconds.
-#hash_interval = 100
-
-# Number of attempts to check the hash while using the mincore status,
-# before forcing. Overworked systems might need lower values to get a
-# decent hash checking rate.
-#hash_max_tries = 10