1 files changed, 110 insertions, 0 deletions
diff --git a/.rtorrent.rc b/.rtorrent.rc
new file mode 100644
index 0000000..3dfa1a2
--- /dev/null
+++ b/.rtorrent.rc
@@ -0,0 +1,110 @@
+# This is an example resource file for rTorrent. Copy to
+# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
+# uncomment the options you wish to enable.
+
+# Maximum and minimum number of peers to connect to per torrent.
+#min_peers = 40
+#max_peers = 100
+
+# Same as above but for seeding completed torrents (-1 = same as downloading)
+#min_peers_seed = 10
+#max_peers_seed = 50
+
+# Maximum number of simultanious uploads per torrent.
+#max_uploads = 15
+
+# Global upload and download rate in KiB. "0" for unlimited.
+#download_rate = 0
+upload_rate = 10
+
+# Default directory to save the downloaded torrents.
+directory = ~/z/
+
+# Default session directory. Make sure you don't run multiple instance
+# of rtorrent using the same session directory. Perhaps using a
+# relative path?
+session = ~/z/
+
+# Watch a directory for new torrents, and stop those that have been
+# deleted.
+#schedule = watch_directory,5,5,load_start=./watch/*.torrent
+#schedule = untied_directory,5,5,stop_untied=
+schedule = low_diskspace,5,60,close_low_diskspace=100M
+
+# Close torrents when diskspace is low.
+#schedule = low_diskspace,5,60,close_low_diskspace=100M
+
+# Stop torrents when reaching upload ratio in percent,
+# when also reaching total upload in bytes, or when
+# reaching final upload ratio in percent.
+# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
+#schedule = ratio,60,60,"stop_on_ratio=200,200M,2000"
+
+# The ip address reported to the tracker.
+#ip = 127.0.0.1
+#ip = rakshasa.no
+
+# The ip address the listening socket and outgoing connections is
+# bound to.
+#bind = 127.0.0.1
+#bind = rakshasa.no
+
+# Port range to use for listening.
+port_range = 49164-50164
+
+# Start opening ports at a random position within the port range.
+port_random = yes
+
+# Check hash for finished torrents. Might be usefull until the bug is
+# fixed that causes lack of diskspace not to be properly reported.
+#check_hash = no
+
+# Set whetever the client should try to connect to UDP trackers.
+#use_udp_trackers = yes
+
+# Alternative calls to bind and ip that should handle dynamic ip's.
+#schedule = ip_tick,0,1800,ip=rakshasa
+#schedule = bind_tick,0,1800,bind=rakshasa
+
+# Encryption options, set to none (default) or any combination of the following:
+# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
+#
+# The example value allows incoming encrypted connections, starts unencrypted
+# outgoing connections but retries with encryption if they fail, preferring
+# plaintext to RC4 encryption after the encrypted handshake
+#
+# encryption = allow_incoming,enable_retry,prefer_plaintext
+encryption = require
+
+# Enable DHT support for trackerless torrents or when all trackers are down.
+# May be set to "disable" (completely disable DHT), "off" (do not start DHT),
+# "auto" (start and stop DHT as needed), or "on" (start DHT immediately).
+# The default is "off". For DHT to work, a session directory must be defined.
+# 
+# dht = auto
+
+# UDP port to use for DHT. 
+# 
+# dht_port = 6881
+
+# Enable peer exchange (for torrents not marked private)
+#
+# peer_exchange = yes
+
+#
+# Do not modify the following parameters unless you know what you're doing.
+#
+
+# Hash read-ahead controls how many MB to request the kernel to read
+# ahead. If the value is too low the disk may not be fully utilized,
+# while if too high the kernel might not be able to keep the read
+# pages in memory thus end up trashing.
+#hash_read_ahead = 10
+
+# Interval between attempts to check the hash, in milliseconds.
+#hash_interval = 100
+
+# Number of attempts to check the hash while using the mincore status,
+# before forcing. Overworked systems might need lower values to get a
+# decent hash checking rate.
+#hash_max_tries = 10